1025 : Evaluation
Tyrion Lannister clocked in at 10:32.
Active Work Request #30023
06/10/17 TxBase Notes: [Insert original notes from TxBase] Ex: Hole in driver's seat cushion.
Active Work Request #23456
06/12/17 TxBase Notes: [Insert original notes from TxBase] Ex: Small chip in windshield, bottom passenger's side.
06/20/17 Defect Notes: [Insert "still defective" notes from iDash] Ex: Still defective; chip has spread to a small (4mm long) crack.
Check All Interior Lights
- In all positions doors open and closed, switching all, off, right, park.
- Check that the front lights dim with the doors closed and brighten when the doors open.
- Check interior light lenses for cleanliness.
- Report if not working or have dirty lenses.
#1234
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Wheelchair Area
- Ensure wheelchair restraints and lap/shoulder belts are clean and operational and the flip-up seats are adjusted and latching correctly.
- Check wheelchair chime operation.
- Ensure the wheelchair and priority seating decals are in place and presentable.
#1234
Defect Notes: Wheelchair decal peeled off/missing on 1st seat driver's side.
Photos: image01.jpg
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Mountings
- Check all stanchions and seat mountings for proper attachment, including the front entrance/stair assist handles.
#1234
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Rear Door
- Check rear door master switch override operation.
- Ensure that the rear door stays open.
- Check brake interlock (should apply brakes when rear door is energized).
- Check condition of bushings, shafts, pins, arms, brushes, grab handles, glass, and seals.
#1234
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Chime
- Check chime cord/switch operation at the rear, the rear door, and the front of the bus.
- Note if stop request signs are not lit up or the audible chime does not sound.
#1234
Defect Notes: Cord at very back of the bus on the driver's side is sagging.
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Check All Exterior Lights/Reflectors
- Include:
- High & low beam headlights
- Destination sign lights
- Marker lights
- Backup lights and beeper
- Turn signal lights
- Rear run taillights
- Brake lights
- Curb and step lights
- Exterior wheelchair light/ramp
- Audible beeper
#1234
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Wiper Blades
- Check condition of wiper blades, wiper arm, and wiper motor mounting tightness.
- Check exterior windshield sealing gaskets.
#1234
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Bike Rack
- Check bike rack grips for wear.
- Verify proper operation of bike rack.
- Visually inspect the decals to ensure readability.
- Lube pivot points with Triflow.
- Report any damage.
#1234
Body Damage
- Check for and report any body damage on body shop worksheet.
#1234
Lug Nuts
- Torque all lug nuts on all wheels to 500 foot-pounds (ft-lbs).
- Check for damaged, rusted, or cracked wheels.
- Report any lugs that required tightening to your Supervisor.
- Record the number of lugs at each wheel that required tightening (enter "0" if no tightening was necessary):
#1234
Tires
- Thump tires to check for low air pressure.
- Check for uneven wear and damage.
- Record tire wear below:
#1234
Batteries
- Check batteries and fill if needed with distilled water. (Part #1003082)
- Check connections in batter & fuse compartment for corrosion and looseness.
- Lubricate battery tray rollers with a Teflon spray lubricant.
- Check battery cable supports, make sure cables are not lying on battery tray slides when batteries are pushed in.
#1234
Add General Inspection Comments (optional):
