1025 : Evaluation
Tyrion Lannister clocked in at 10:32.
Samwell Tarly clocked in at 10:43.
Lug Nut Check
-
-
Torque all lug nuts on all wheels to 500 ft. lbs.
-
Check for damaged, rusted or cracked wheels.
-
Record below the number of lugs at each wheel that required any tightening in order to reach torque specification.
-
Report any lugs that required tightening below to your Supervisor.
-
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Check All Interior Lights
- In all positions doors open and closed, switching all, off, right, park.
- Check that the front lights dim with the doors closed and brighten when the doors open.
- Check interior light lenses for cleanliness.
- Report if not working or have dirty lenses.
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Wheelchair Area
- Ensure wheelchair restraints and lap/shoulder belts are clean and operational and the flip-up seats are adjusted and latching correctly.
- Check wheelchair chime operation.
- Ensure the wheelchair and priority seating decals are in place and presentable.
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Mountings
- Check all stanchions and seat mountings for proper attachment, including the front entrance/stair assist handles.
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Rear Door
- Check rear door master switch override operation.
- Ensure that the rear door stays open.
- Check brake interlock (should apply brakes when rear door is energized).
- Check condition of bushings, shafts, pins, arms, brushes, grab handles, glass, and seals.
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Chime
- Check chime cord/switch operation at the rear, the rear door, and the front of the bus.
- Note if stop request signs are not lit up or the audible chime does not sound.
Notes: Cord at very back of the bus on the driver's side is sagging.
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Check All Exterior Lights/Reflectors
- Include:
- High & low beam headlights
- Destination sign lights
- Marker lights
- Backup lights and beeper
- Turn signal lights
- Rear run taillights
- Brake lights
- Curb and step lights
- Exterior wheelchair light/ramp
- Audible beeper
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Wiper Blades
- Check condition of wiper blades, wiper arm, and wiper motor mounting tightness.
- Check exterior windshield sealing gaskets.
Notes: Wiper blade worn and needs replacing.
Completed by: Jon Snow on MM/DD/YY @ HH:MM
Bike Rack
- Check bike rack grips for wear.
- Verify proper operation of bike rack.
- Visually inspect the decals to ensure readability.
- Lube pivot points with Triflow.
- Report any damage.
Body Damage
- Check for and report any body damage on body shop worksheet.
Lug Nuts
- Torque all lug nuts on all wheels to 500 foot-pounds (ft-lbs).
- Check for damaged, rusted, or cracked wheels.
- Report any lugs that required tightening to your Supervisor (?)
- Record the number of lugs at each wheel that required tightening (enter "0" if no tightening was necessary.):
Tires
- Thump tires to check for low air pressure.
- Check for uneven wear and damage.
- Record tire wear below:
Measurements
Add General Inspection Comments (optional):